45+ How To Put A Bobbin Into A Sewing Machine New. This is usually found near the needle on the sewing machine. Start passing the thread to the left side of the sewing machine and wind it around the pretension disc.
Catch the latch of the bobbin case to open it; Leave a tail of about 3 to 4 inches of thread and place the bobbin in the bobbin case. Then turn gently clockwise until you can see both screws engaged on their posts once.
To Put The Bobbin In The Sewing Machine, First, Locate The Bobbin Case.
There is a lot of cases of getting hurt by the needle while setting the bobbin. Put the threaded bobbin into the case so the thread will turn correctly Raise the needle to the highest position via the wheel;
As Have Indicated Above, The Primary Function Of Bobbins Is To Supply Thread While Sewing.
This is usually found near the needle on the sewing machine. Remove the bobbin case by flipping the hinge arm, rotate, and pull it out. Cut the thread, leaving a tail of about 6 inches.
Open The Cover Below The Needle Plate So You Can See The Bobbin Case.
After you put your bobbin case back into the sewing machine, turn the tension dial to. Open the bobbin area by removing the extension table. Start passing the thread to the left side of the sewing machine and wind it around the pretension disc.
Check That The Tension Is Properly Set By Pulling Gently On The Loose Thread.
Pull the bobbin thread up. Raise the needle to the highest position by turning the handwheel toward you. Join aneka for the third video in our sewing for beginners series and learn how to load a.
Catch The Latch Of The Bobbin Case To Open It;
It should be held securely. Begin passing thread into the bobbin winder. A bobbin case holds the bobbin in place.
